Ricoh AP610N - Aficio B/W Laser Printer - 5. Troubleshooting; Error & Status Messages on the Control Panel; Printer Does Not Print; Checking the port connection

49
4. Adjusting the Printer
Adjusting the Image Density
You can adjust the image density
when the print side of the page is
shaded or print image is too light.
Important
❒ Extreme settings may create print-
outs that appear dirty.
❒ Image density settings should be
made from the application or the
printer driver whenever possible.
A Press the {Menu} key.
The [Menu] screen appears on the
display.
B Press the {U} or {T} key to dis-
play [Maintenance], and then press
the {# Enter} key .
The maintenance menu appears.
C Check [Image Density] is displayed,
and then press the {# Enter} key.
D Press the {U} or {T} key to set the
image density value.
Note
❒ To maintain a darker image un-
der high volume printing condi-
tions, we highly recommended
that you select 3 from the con-
trol panel.
❒ You can adjust the image densi-
ty in seven steps from -3 to +3.
Increasing the value makes the
printouts darker and decreasing
the value makes the printouts
lighter.
E Press the {# Enter} key .
Return to the maintenance menu.
F Press the {Online} key.
The initial screen appears.
Menu:
Maintenance
AGN503S
Image Density:
(-3 +3) 0
KirP4GB_Mainte-F6_FM_forPaper.book Page 49 Thursday, May 12, 2005 11:48 AM