21
Quick Guide
Turning the Power On/Off
To turn the power on:
1. Slide the power switch to open the
lens cover.
After the start sound, the auto-focus/flash
lamp blink for several seconds.
Using the Camera in Playback Mode
If the Playback button is pressed with the lens
cover closed, the power is turn on in Playback
Mode and the camera can be used in this
mode.
To turn the power off:
1. Slide the power switch to close the lens cover.
Note
If the LCD monitor does not come on
When the Power-Save mode is set to ON, the LCD monitor does not come on during the Still
Image/Movie mode. Display the SETUP menu to turn the Power-Save mode OFF.
Power-Save Mode
The power consumption of the LCD monitor can be reduced and the battery life extended by
setting the Power Saving mode to on.
Auto Power Off
If the camera goes unused for a set period of time, it will automatically turn itself off to save
power. To continue on using the camera, slide the power switch to close the lens cover once
(power-off) and slide it again to open (power-on).
Reference
• For how to activate Power Save Mode, see P.104.
• For how to change the Auto Power Off setting, see P.102.
To Next Page
Loading...
