Ricoh Caplio RR30 - Changing Power-Save Mode Settings (POWER SAVE)

96
Chapter 1 / Section 6 Changing Camera Settings
To change the Power-Save Mode, follow the
steps below.
Turn the Mode Dial to (Setup Mode).
The Setup Screen appears.
Press the button to select [POWER
SAVE].
Press to select the desired setting.
This setting will be used until you change it.
O
FF (Power Save Mode Inactivated) ⁄ Set at purchase
O
N (Activate Power Save Mode)
Possible Settings
Changing Power-Save Mode Settings (POWER SAVE)
You can reduce the power consumption of the LCD Monitor and extend the life of your batteries.
At the time of purchase, Power-Save Mode is set to [OFF].
If you have activated Power Save mode, power consumption will be less, but there are the following limitations.
• The display on the LCD Monitor will turn off. Press the (Quick Review) button or the button to turn
the LCD Monitor Display on, and then press them again to turn the display off. You cannot turn the LCD
Monitor Display on/off by pressing the (Self-timer), (Flash) or (Macro) buttons.Processing time
may be slower.
• It works only in Shooting Mode. It does not work in Playback Mode.