Adjusting the Printer
73
A Press the {Menu} key.
“Menu” appears on the display.
B Press the {U} or {T} key to display “Maintenance”, and then press the
{# Enter} key.
The maintenance menu appears.
C Press the {U} or {T} key to display “Color Calibrate”, and then press the
{# Enter} key.
❒ If you perform only correction 2, proceed to step
L
.
D Check “Start Calibr. 1” is displayed, and then press the {# Enter} key.
E Check “Yes” is displayed, and press {# Enter} key to print gradation cor-
rection sheet 1.
F Set the gradation correction value of the highlighted part using correc-
tion 1. For setting K (black) gradation, hold the correction value (0-6) for
“K” of the correction value setting sheet 1 over the color sample (K) for
gradation correction 1 of the Color Calibration Sample Sheet, and set
the numerical value of the closest color using either the {U} or {T} key.
Set the correction value using the supplied Color Calibration Sample Sheet
and the gradation correction sheet 1 printed in the previous step.
Set M (magenta), C (cyan), and Y (yellow) using the same method.
Menu:
Maintenance
Calibrate 1:
K:3 M:3 C/Y:3/3
To Next Page
Loading...
Need help?
General
