Ricoh GR Digital - Displaying a Setting Change Warning (SHTG STGS WARNG.)

137
Changing Camera Settings
3
Displaying a Setting Change Warning
(SHTG STGS WARNG.)
You can set the icon of a changed function to blink or a warning
message indicating a change will be displayed at power-on for about
5 seconds if the initial settings are changed for the following
functions.
•White Balance
•Focus
•ISO Setting
• Exposure Comp.
If you operate a camera button while an icon is blinking, the icon
stops blinking and lights steadily.
If you operate a camera button during a warning message display,
the message disappears.
To set whether to enable (ON) or disable (OFF) the shooting setting
alert, follow the steps below.
1. Display the setup menu.
For detailed operation, see P.123.
2. Press the " button to select
[SHTG STGS WARNG.] and press
the $ button.
3. Press the !" buttons to select
the desired setting.
4. Press the M/O or # button.
5. If you pressed the # button in step
4, press also the M/O button.
This setting will be used until you change it.
Possible Settings
OFF
ON *Setting upon purchase