Loading the 2000-sheet drawer
54
Printing
3 Slightly bend the stack of print media as shown, and place it on the elevator tray with the preferred print side
facing down. Align the stack of print media to the back of the drawer.
Note: For duplex printing, letterhead or other preprinted paper must be loaded differently.
Carefully align each stack as you load it to ensure a smooth edge where the stacks meet. Do not load print media
above the load line.
Note: When loading more than one ream of paper, we recommend you remove the top and bottom sheet.
4 Close the loading door.
Simplex (single sided)
Duplex
To Next Page
Loading...
