Pre/Postprocessor Status
Displays the status of any attached pre- and postprocessors and the values for the
following postprocessor settings:
v Offsetter Enabled
v BTS Enabled
v Offset on Mark Forms
v Internal Stacker Enabled
The service representative configures any attached preprocessors and
postprocessors when they are installed and sets the state of each device to Enabled
or Disabled. Pre- and postprocessors are enabled or disabled using the
Pre/Postprocessor panel on the printer console.
Operator Messages
Displays all active operator messages. Message text is preceded by a colored icon
that represent errors, warnings, and informational messages.
Note: If applicable to the web page you are viewing, you may be able to use the
browser Search, Find, and Print functions.
Print Quality
Displays the following settings for print quality:
v Contrast
v Boldness
v Preheat Temperature
v Fuser Temperature
v Oil Rate
v Oil Belt
v User Backup Idler Roll
v Preheat Offset
Print quality settings are defined using the Print Quality panel on the printer
console.
Note:
If applicable to the web page you are viewing, you may be able to use the browser
Search, Find, and Print functions.
To display the general help system, select the Help button in the tool bar at the top
of the web page. Select the ? at the top of the current web page to display the help
topic for the web page you are currently viewing. Help topics are displayed inside
a separate help system browser.
Chapter 9. Accessing the printer from a remote location 399
To Next Page