Troubleshooting > Print Results Do Not Match the Displayed Image > Characters and Colors Do Not Match the Displayed Image
Characters and Colors Do Not Match the Displayed Image
If there are differences between the characters and colors of the print results and the displayed image, the following
questions should be addressed.
Has the hue of colors been adjusted?
Since printed colors and screen colors are produced by different methods, a color printed and a color displayed on a
screen can have different hues even though they are the "same" color. Use the color matching function to make the
hue of printed colors and displayed colors closer. See
Changing the Color Profiling Pattern .
Has the nozzle check been performed?
The print-heads may be clogged and the amount of ink may not be able to be regulated. Print the nozzle check test
pattern and clean the print-heads as necessary. See
Clean Print-heads (Normal) and Nozzle Check .
Was printing done in black and white?
Check the color setting of the application and the color print setting of the printer driver. See
Printing in Black and
White .
Have the print quality settings been made?
Set the printing resolution to an appropriate level. See
Printing Using Preset Print Quality Settings .
Does the paper type setting match?
Make sure that the paper type setting of the printer driver matches the type of paper loaded. See
Printing on Various
Paper Types .
Have you tried printing with inkjet plain paper?
Try printing with inkjet plain paper. The print results should be clearer. See
Printing on Various Paper Types .
Changing the printer driver setting
You may eliminate certain problems by changing the printer driver settings as described below:
● Cannot print certain data properly when using a certain application, or cannot print image data properly.
In the [Print Quality] area, select [Standard (quality priority)] or [High quality], and then print. See
Printing
Using Preset Print Quality Settings .
In the [Change User Settings] dialog box, on the [Image Adjustments] tab, under [Dithering], deselect the
[Use error diffusion] check box. See
Using Error Diffusion .
Set [Spool format:] to [RAW] or [EMF] in the [Printer Configuration] dialog box.
In the [Change User Settings] dialog box, on the [Image Adjustments] tab, under [Image processing
file:///E|/shared/pdf-work/newfiles/pp2w/Op_Guide/int/0122.htm (1 of 2)2005/10/05 12:05:04
To Next Page
Loading...
