6
Handling the Machine's Interior
R WARNING:
R CAUTION:
• To avoid hazardous electric shock or laser radiation exposure, do not
remove any covers or screws other than those specified in this man-
ual.
• Do not take apart or attempt any modifications to this machine. There
is a risk of fire, electric shock, explosion or loss of sight. If the ma-
chine has laser systems, there is a risk of serious eye damage.
• The fusing section of this machine might be very hot. Caution should be tak-
en when removing misfed paper.
• The inside of this printer becomes very hot. Do not touch parts labelled “v”
(indicating a hot surface). Touching these parts will result in burns.
• When removing misfed paper, do not touch the fusing unit because it could
be very hot.
• Do not touch the inside of the controller board compartment. It may cause
a machine malfunction or a burn.
• Wait at least one hour after power off before replacing parts. Not allowing
the printer to cool may result in burns.
• Before installing options, the machine should be turned off and unplugged
for at least half an hour. Components inside the machine become very hot,
and can cause a burn if touched.
• During operation, rollers for transporting the paper revolve. A safety device
is being installed so that the machine can be operated safely. But take care
not to touch the machine during operation. An injury might occur.
• When loading paper, take care not to trap or injure your fingers.
• Fire and breakdown can result from heavy accumulation of dust inside this
machine. Consult your service representative for details about and charges
for cleaning the machine's interior.
• Do not pull out the paper tray forcefully. If you do, the tray might fall and
cause an injury.
• Keep your hands clear of the booklet finisher tray when pulling out or push-
ing in the finisher's staple unit. You can trap your fingers if you do not.
• Lifting the paper feed unit carelessly or dropping it may cause injury.
To Next Page
Loading...
Need help?
General
