Ricoh MP 3055 Series - Canceling a Transmission after the Original Is Scanned

1. Press the [Stop] key.
CXX006
2. Press [Cancel Scanning] or [Cancel TX].
Depending on the transmission mode and function you use, either [Cancel Scanning] or [Cancel
TX] is displayed.
Canceling a Transmission After the Original Is Scanned
Use this procedure to cancel a transmission after the original is scanned.
You can cancel transmission of a file while the file is being sent, stored in memory, or if it fails to transmit.
All the scanned data is deleted from memory.
1. Press the [Stop] key.
CXX006
You can also press [TX/RX Status / Print], and then [Check / Stop Transmission File].
2. If a confirmation message appears, press [Standby File List].
3. Select the file you want to cancel.
If the desired file is not shown, press [ ] or [ ] to find it. To cancel transmission of a file stored in the
memory, press the [File List] tab.
4. Press [Stop Transmission].
Canceling a Transmission
99