Messages Displayed When Using the Facsimile
Function
Message Causes Solutions
"Cannot find the specified
path. Please check the
settings."
The name of the computer or
folder entered as the
destination is wrong.
Check that the computer name and the
folder name for the destination are
correct.
"Error occurred, and
transmission was
cancelled."
• Original jammed during
Immediate Transmission.
•
A problem occurred in
the machine, or noise
occurred on the
telephone line.
Press [Exit], and then send the
documents again.
"Functional problem
occurred. Stopped
processing."
The power was turned off
while the machine was
receiving a document by
Internet Fax.
Even if you turn on the power
immediately, depending on the mail
server, the machine might not be able
to resume reception of the Internet Fax
if the timeout period has not expired.
Wait until the mail server's timeout
period has expired, and then resume
reception of the Internet Fax. For
details about reception of the Internet
Fax, contact your administrator.
"Functional problems with
facsimile. Data will be
initialized."
There is a problem with the
fax.
Record the code number shown on the
screen, and then contact your service
representative. Other functions can be
used.
"Memory is full. Cannot
scan more. Transmission will
be stopped."
The memory is full. If you press [Exit], the machine returns
to standby mode and starts transmitting
the stored pages.
Check the pages that have not been
sent using the Communication Result
Report, and then resend those pages.
"Put original back, check it
and press the Start key."
Original jammed during
Memory Transmission.
Press [Exit], and then send the
documents again.
Messages Displayed When Using the Facsimile Function
185
To Next Page
Loading...
