Log ID
Identifies the ID that is assigned to the log. This is a hexadecimal ID that identifies the log.
Power Mode
The power status of the machine (after state transition) is logged.
Value Content
Standby Standby status
Low Power Low power status
Silent Silent status
HDD On HDD on status
Engine Off Engine off status
Controller Off Controller off status
STR STR status
Silent Print Silent print status
Low Power Print Low power print status
Fusing Unit Off Fusing unit off status
Log Type
The type of job log is recorded.
Job Interval (seconds)
Indicates the elapsed time from the start of the previous job to the start of the present job.
Job Duration (seconds)
Indicates the elapsed time from the start of a job to its end.
Paper Usage (Large Size)
Indicates the number of one-sided prints per hour on large paper.
Large size means A3 (11 × 17 inches) or larger.
Paper Usage (Small Size)
Indicates the number of one-sided prints per hour on small paper.
Small size means smaller than A3 (11 × 17 inches).
Paper Usage (2 Sided: Large Size)
Indicates the number of two-sided prints per hour on large paper.
7. Managing the Machine
230
To Next Page
Loading...
