Ricoh MP 4054 Series User Guide

13. Enter the password of the destination computer, and then press [OK].
14. Enter the password again to confirm, and then press [OK].
15. Press [Folder].
16. Check that [SMB] is selected.
17. Press [Change] or [Browse Network], and then specify the folder.
To specify a folder, you can either enter the path manually or locate the folder by browsing the
network.
18. Press [Connection Test] to check the path is set correctly.
19. Press [Exit].
If the connection test fails, check the settings, and then try again.
20. Press [OK].
21. Close the Address Book screen.
• When using the standard operation panel
Press the [User Tools/Counter] key.
• When using the Smart Operation Panel
Press [User Tools/Counter] ( ) on the top right of the screen.
Locating the SMB folder manually
1. Press [Change] under "Path".
2. Enter the path where the folder is located.
For example: if the name of the destination computer is "User", and the folder name is "Share", the
path will be \\User\Share.
6. Scan
138

Ricoh MP 4054 Series Specifications

General

Print Resolution	1200 x 1200 dpi
Duplex Printing	Yes
Hard Disk Drive	320 GB
Copy Resolution	600 x 600 dpi
Print Speed	40 ppm
Paper Capacity	1, 200 sheets standard, up to 4, 700 sheets maximum
Maximum Paper Size	11" x 17"
Memory	2 GB
Connectivity	Ethernet, USB
Functions	Print, Copy, Scan
Scan Resolution	600 dpi
Fax Transmission Speed	33.6 kbps
Copy Speed	40 ppm (B&W)
Operating System Compatibility	Windows, Mac, Linux