Ricoh MP C2011 User Manual

Loading Paper into the Bypass Tray
Use the bypass tray to use OHP transparencies, adhesive labels, translucent paper, and paper that
cannot be loaded in the paper trays.
• The maximum number of sheets you can load at the same time depends on paper type. Do not
stack paper over the limit mark. For the maximum number of sheets you can load, see page 117
"Recommended Paper Sizes and Types".
1. Open the bypass tray.
DAV001
2. Load the paper face down until you hear the beep.
3. Align the paper guides to the paper size.
If the guides are not flush against the paper, images might be skewed or paper misfeeds might
occur.
DAV002
• When you use the bypass tray, it is recommended to load the paper in orientation.
• Certain types of paper might not be detected properly when placed on the bypass tray. If this
happens, remove the paper and place it on the bypass tray again.
• Pull the extender out when loading sheets larger than A4 , 8
1
/
2
× 11 in the bypass tray.
8. Adding Paper and Toner
108

Ricoh MP C2011 Specifications

General

Print Technology	Laser
Print Speed (Black)	20 ppm
Print Speed (Color)	20 ppm
Max Print Resolution	1200 x 1200 dpi
Copy Speed (Black)	20 cpm
Copy Speed (Color)	20 cpm
Copy Resolution	600 dpi
Multiple Copy	Up to 999 copies
Paper Output	250 sheets
Duplex Printing	Yes
Processor	600 MHz
Memory (Standard)	1.5 GB
Memory (Maximum)	1.5 GB
Hard Disk Drive (Optional)	250 GB
Power Source	220-240V, 50/60Hz
Fax Transmission Speed	33.6 kbps
Max Paper Size	A3
Network Connectivity	Ethernet
Scan Resolution	600 dpi
Functions	Print, Copy, Scan
Zoom	25% to 400%
Scan Speed (Black)	54 ipm
Scan Destinations	Email, Folder, USB
Paper Sizes	A3, A4, A5, B4, B5
Interface	USB 2.0, Ethernet
Network Protocol	TCP/IP, IPv4, IPv6
Operating System Compatibility	Windows, Mac, Linux
First Print Time (Color)	11 seconds or less