Ricoh MP W6700

Message Cause Solution
"There is no response from
the scanner."
The network is crowded. Wait for a while, and then connect to
the network again.
"Scanner is not available.
Scanner memory is in use for
other function."
A function of the machine
other than the Scanner
function is being used such
as the Copier function.
• Wait for a while, and then
connect to the network again.
• Cancel the job that is being
processed. Press the [Stop] key.
Follow the instructions in the
message that appears and exit
the function that is running.
"Scanner is not available on
the specified device."
The TWAIN scanner function
cannot be used on this
machine.
Contact your service representative.
"Scanner is not ready.
Check the scanner and the
options."
The original cover is open. Check whether the original cover is
closed.
"The scan mode name
already exists. Do you want
to overwrite it?"
You tried to register a name
that is already in use.
Use another name.
When there is a problem connecting to the scanner
Message Cause Solution
"Scanner is not available.
Check the scanner
connection status."
The machine's power is off. Turn on the power.
Messages Displayed When You Use the Scanner Function
161