6. Press the [ ] or [ ] key to select [Enable Wi-Fi], and then press the [OK] key.
7. Press the [ ] or [ ] key to select [Enable], and then press the [OK] key.
8. Press the [Menu] key to return to the Initial screen.
9. Turn off the machine, and then turn it back on.
10. Press the [Menu] key.
11. Press the [ ] or [ ] key to select [Wi-Fi Setup Wizard], and then press the [OK] key.
12. Enter the administrator password.
13. Press the [ ] or [ ] key to select SSID of the router (access point) from the searched SSID
list, and then press the [OK] key.
The next steps differ depending on the authentication method that you have selected.
• If the authentication method is set to WPA2-PSK or Mixed Mode, proceed to Step 14.
• If the authentication method is set to Open System or Shared Key, proceed to Step 17.
• If the authentication method has not been configured, proceed to Step 19.
14. Enter the encryption key using the [ ] or [ ] key, and then press the [OK] key.
As the passphrase, you can enter either 8 to 63 ASCII characters (0x20-0x7e) or 64 hexadecimal
digits (0-9, A-F, a-f).
• To go to the next characters, press the [OK] key.
• Press the [Back] key to clear all characters.
• Press the [ ] key to delete characters one by one backwards from the end.
15. Press the [OK] key.
After connecting to the network, the Wi-Fi screen is displayed.
16. Check the connection status in [Wi-Fi Status] in [Network Settings].
When "Connected" is displayed, the connection has been established. It is not necessary to
proceed to next step.
• When "Connecting" is displayed, the connection is being established.
• When "Disconnected" is displayed, the connection has not been established. Start again from
the beginning.
17. Enter the encryption key using the [
] or [ ] key, and then press the [OK] key.
• To go to the next characters, press the [OK] key.
• Press the [Back] key to clear all characters.
• Press the [
] key to delete characters one by one backwards from the end.
18. Enter the ID using the [
] or [ ] key, and then press the [OK] key.
The ID is used for identifying the encryption key. You can register four encryption keys (ID 1 to 4).
8. Configuring Network Settings
190
To Next Page
Loading...
