To Next PageTo Next PageWhat to do if my Ricoh PJ X3340N Projector displays 'Temperature Error' and turns off?
If your Ricoh Projector displays a 'Temperature Error' and turns off, place the projector so that the intake and exhaust vents are not blocked. Then, disconnect the power cord, wait a while, and turn the projector on again.
Why does my Ricoh PJ X3340N turn off during use?
Ensure that the environment where you're using the Ricoh Projector is within the acceptable temperature range and that the vents are not blocked.
What to do if my Ricoh PJ X3340N displays 'Hardware Error' and turns off?
If your Ricoh Projector displays a 'Hardware Error' and shuts down, disconnect the power cord, wait a short time, and then try turning the projector back on. If the problem persists, contact your service representative.
Why does my Ricoh PJ X3340N not turn on?
If your Ricoh Projector doesn't turn on, it may have malfunctioned. Disconnect the power cord and contact your service representative.
Why does my Ricoh PJ X3340N power off during use?
If your Ricoh Projector's power turns off during use: * Ensure the projector is being used within the acceptable temperature range. * Check that the vents are not blocked.
Why won't the lamp on my Ricoh PJ X3340N turn off and keeps flashing?
If the lamp on your Ricoh Projector does not turn off and flashes every 2 seconds, it means that the projector has malfunctioned. Disconnect the power cord, wait a while, and then turn on the projector again. If the problem persists, contact your service representative.
How to troubleshoot a Ricoh Projector when power does not turn on?
To address the issue of power not turning on for your Ricoh Projector: * Ensure the power plug or connector is correctly connected. * Confirm that the lamp cover is properly mounted.
What does 'Fan Error' mean on a Ricoh PJ X3340N Projector?
If the Ricoh Projector displays a "Fan Error" and turns off, the cooling fan has likely malfunctioned. Disconnect the power cord, and contact your service representative.
What to do if Ricoh Projector displays 'Hardware Error'?
If the Ricoh Projector displays a "Hardware Error" and turns off, it indicates a malfunction. Disconnect the power cord, wait a while, and then turn the projector on again. If the problem persists, contact your service representative.
Why does my Ricoh PJ X3340N turn off and flash every 1 second?
If your Ricoh Projector turns off during operation or doesn't turn on and the interval flashes every 1 second, it's likely that the lamp cover isn't installed correctly. Disconnect the power cord and then reinstall the lamp cover properly.
General| Resolution | XGA (1024 x 768) |
|---|---|
| Projection Lens Zoom Ratio | 1.2x |
| Screen Size | 30 - 300 inches |
| Connectivity/Input Ports | HDMI, VGA, S-Video, Audio In |
| Output Ports | VGA, Audio Out |
| Video Compatibility | NTSC, PAL, SECAM, 480i, 480p, 576i, 576p, 720p, 1080i, 1080p |
| Network | RJ-45 (LAN) |
| Power Consumption | 0.5 W (Standby) |
