CIP Training Plockmatic SquareBack Trimmer
Setting Up a Job
Booklet Production
Booklet Production
When the printer is started, Booklet
Production starts automatically and
this screen is shown on the GUI.
The operator can adjust the finishing
settings while the booklets are being
produced by pressing [Adjust Set-
tings].
This will show again the Main Menu
on the screen.
The user can then modify the finish-
ing settings as described earlier in
this section.
NOTE:
while producing the book-lets, due to
physical constraints, Face Trim can only
be adjusted by a maxi-mum of +3mm
or - 3mm.
To Next Page
Loading...
