Problems Causes Solutions
The function does not run or
cannot be used.
The function cannot be
performed while the Address
Book is being backed up from
Web Image Monitor or other
tools running on the computer.
Wait a while. When the
Address Book backup is
complete, the function will be
performed.
Paper is bent. Paper may be bent when it is
ejected from the finisher upper
tray.
Change the output tray to the
finisher shift tray.
The print image is not properly
positioned on the paper.
The machine has not detected
the paper type and/or width
correctly.
Contact the machine
administrator or your service
representative.
The print image is not properly
positioned on the paper.
The print position is not aligned
properly.
Contact the machine
administrator or your service
representative.
Paper delivered to the high
capacity stacker is curled,
causing it to not align properly.
Paper is curled. • When the paper is curled
downward, select [Adjust
Curl: Weak] or [Adjust
Curl: Strong] under
[Adjust Paper Curl] in
"Adjustment Settings for
Operators".
• When the paper is curled
upward, select [Adjust
Curl: Weak] or [Adjust
Curl: Strong] under [Adjust
Paper Curl] in "Adjustment
Settings for Operators".
For details about the Adjustment
Settings for Operators, see
"Adjustment Settings for
Operators", Paper Settings .
9. Troubleshooting
172
To Next Page
Loading...
