Problems Causes Solutions
Output paper to the stacker tray
does not align properly.
• When using coated paper,
the output paper to the
stacker tray might fail to
align properly.
• When the paper weight is
280.0 g/m
2
or more, and
the paper size is A3, SRA3
or larger, the output paper
to the stacker tray might
fail to align properly.
Select [Adjust Curl: Weak]
or [Adjust Curl: Strong]
under [Adjust Paper Curl] in
"Adjustment Settings for
Operators".
For details about the Adjustment
Settings for Operators, see
"Adjustment Settings for
Operators", Paper Settings .
Fold
Problems Causes Solutions
Wrinkling occurs when Gate
Fold, Letter Fold-in, or Letter
Fold-out is applied.
Wrinkling can occur if Gate
Fold, Letter Fold-in, or Letter
Fold-out is applied to B4 JIS
(Japanese Industrial Standard)
, A3 , 8
1
/
2
" 14" , 11"
17" , 12" 18" , 8K , or
larger sizes of paper.
When applying Gate Fold,
Letter Fold-in, or Letter Fold-out
to paper larger than A4, we
recommend you enable image
reduction and use paper no
larger than A4 .
When you print Z-folded paper,
the machine indicates that the
output tray is full even though
the amount of output paper on
the tray is less than the stack
capacity.
The Z-fold support tray is not
set.
Set the Z-fold support tray for
finisher or multi-folding unit. For
details about how to add the Z-
fold support tray, see "When
using the Z-fold function",
Getting Started .
The multi-folding unit outputs
sheets with creased edges when
Gate Fold is applied.
The paper is curled. • Remove the paper, and
then reload it upside
down.
• Remove the paper, and
then reload it in the
opposite direction.
When You Have Problems Operating the Machine
173
To Next Page
Loading...
