Problem Cause Solution
Cannot print in duplex
mode.
You have selected a paper
type that cannot be used for
duplex printing.
In "Tray Paper Settings", select a paper
type that can be used for duplex
printing. For details about setting
"Paper Type", see "Tray Paper
Settings", Paper Settings.
The machine does not turn
off in 13 minutes after the
main power is turned off.
The machine cannot perform
the shutdown procedure.
Repeat the shutdown procedure. If the
machine does not turn off, turn off the
AC power switch.
An error has occurred when
the Address Book is
changed from the display
panel or Web Image
Monitor.
The Address Book cannot be
changed while you delete
the multiple stored
documents.
Wait a while, and then retry the
operation.
Paper is bent. Paper may be bent when it is
ejected from the finisher
upper tray.
Change the output tray to the finisher
shift tray.
The print image is not
properly positioned on the
paper.
• The machine has not
detected the paper
type and/or width
correctly.
• The print position is not
aligned properly.
Contact the machine administrator or
your service representative.
When You Have Problems Operating the Machine
109
To Next Page
Loading...
