Messages Displayed When You Use the Printer
Function
This section describes the principal messages that appear on the display panel, error logs or reports. If
other messages appear, follow their instructions.
Messages Displayed on the Control Panel When You Use the Printer Function
• Before turning off the power, see "Turning On/Off the Power", Getting Started.
Message Cause Solution
"Exceeded the maximum
number of sheets possible
for Ring Binding with the
currently set binding ring
combs. Printing will be
stopped."
The ring combs currently
loaded are too small for the
number of sheets that need to
be bound.
Change to ring combs that are big
enough to bind the sheets.
"Exceeded max. No. of
sheets possible for Ring
Binding."
The number of sheets per set
exceeds the limit for Ring
Binding.
Check the maximum number of
sheets that can be ring bound. For
details about the limit for Ring
Binding, see "Specifications for Ring
Binder", Maintenance and
Specifications.
"Hardware Problem:
Ethernet"
An error has occurred in the
Ethernet interface.
Turn off the power, and then back on
again. If the message appears
again, contact your service
representative.
"Hardware Problem: HDD" An error has occurred in the
hard disk.
Turn off the power, and then back on
again. If the message appears
again, contact your service
representative.
"Hardware Problem: USB" An error has occurred in the
USB interface.
Turn off the power, and then back on
again. If the message appears
again, contact your service
representative.
6. Troubleshooting
112
To Next Page
Loading...
