Technical Bulletin PAGE: 2/3
Reissued: 26-Aug-16
SOLUTION
Production line
The filter will be changed to an external type, so that it is easier to clean.
Applied from: August 2016 production
Note: The filter in the photo is a prototype, and is different in color than the production-
level part.
In the field
Replace the filter with the new type (see PROCEDURE below).
PROCEDURE
Parts required:
Positioning sponge: D7771294 (SEAL:BLOWER:DUCT) * 2
Filter Ass’y: D7771295 (COVER:FILTER:ASS'Y)
1. Remove the rear covers.
2. Peel off the filter [A].
3. Reattach the rear covers.
To Next Page
Loading...
