Ricoh PRO C7210X - Page 233

1.SC Codes
229
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Replace the signature exit roller motor.
 Replace the LE detect sensor.
 Replace the slave control board.
 Replace the cutter control board
 Replace the motor harness.
 Replace the sensor harness.
 Replace the harness.
 Clear the signature jam.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC751-
34
D
Perfect Binder: Trim unit entrance sensor late error
The stack was late arriving because the trim unit entrance sensor did not go ON
even after a transport end signal was received.
 Trim unit entrance sensor connector loose, broken, defective
 Sensor defective
 Reconnect the connector.
 Replace the signature exit roller motor.
 Replace the entrance path sensor.
 Replace the slave control board.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC751-
35
D
Perfect Binder: Book registration sensor late error
At the start of cutter registration, the book registration did not go ON. The stack
could not be detected for fore edge cutting.
 Book registration sensor connector loose, broken, defective
 Sensor defective
 Reconnect the connector.
 Replace the book registration sensor.
 Replace the cutter control board.
 Replace the sensor harness.
 Clear the signature jam.