Ricoh PRO C7210X - Page 236

1.SC Codes
232
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Book failed to reach output tray
 Fore edge trim scraps fell into output area
 Not detected
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC751-
42
D
Perfect Binder: Trimming jam error
 The edge press plate HP sensor remained OFF after disposing of the trimmed
paper and the trimmings buffer was moved 19 mm to the right.
 After the trimmings buffer door was opened and closed tto check for paper
scraps, the machine detected paper scrap jam 3 times (and issued the alarm
after the 2nd detection).
 There are scraps in the trimmings buffer and at the edge press plate
 Edge press plate HP sensor connector loose, broken, defective
 Sensor defective
 Reconnect the connector.
 Replace the trimming buffer motor.
 Replace the edge press plate HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC751-
43
D
Perfect Binder: Sub grip unit lag error
When the sub grip unit was checked for the presence of paper, no paper could be
detected even after opening the sub grip unit.
 Paper remains in the sub grip unit.
 Sub grip paper sensor connector loose, broken, defective
 Reconnect the connector.
 Replace the SG motor.
 Replace the sub grip paper sensor.
 Replace the slave control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.