Ricoh PRO C7210X - Page 247

1.SC Codes
243
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Replace the front door lock release sensor.
 Replace the master control board.
 Replace the SOL harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC751-
68
D
Perfect Binder: Front door lock release error
The front door lock release sensor did not go ON, even though the door was
unlocked.
 Front door lock solenoid defective
 Front door lock release sensor defective
 Connector loose, broken, defective
 Reconnect the connector.
 Replace the front door lock solenoid.
 Replace the front door lock release sensor.
 Replace the master control board.
 Replace the SOL harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC751-69
D
Perfect Binder: Front door force open error
The front door was detected open, even though it was locked.
 Front door switch defective
 Front door solenoid defective
 Connector loose, broken, defective
 Reconnect the connector.
 Replace the front door lock solenoid.
 Replace the front door switch.
 Replace the master control board.
 Replace the SOL harness.
 Replace the SW harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC751-
70
D
Perfect Binder: Switchback flapper HP sensor late error
During the switchback flapper lift operation, the switchback flapper HP sensor did
not go ON, even though the switchback flapper motor operated long enough for
lifting through an arc of 50 degrees.