Ricoh Pro C9210 - Staple Position for Booklet; Folding Position for Booklet; Paper Alignment for Booklet: Across Feed; Set Number of Folds for Booklet

No. Item Description
0507 Screw-on Cap to Replace Close the Toner Bottle Cap.
Open the toner bottle cover (the cover of the toner
dispensing section) before executing this function.
Afterward, remove the toner bottle by pushing the knob
below the bottle.
0508 Execute Developer
Refreshing
The machine uses degraded toner in the development
unit and adds new toner from the toner bottle.
0509 Execute Photoconductor
Refreshing
Remove dust on the drum surface.
0510 Execute Charger Unit
Cleaning
Cleans the Charge Unit.
0512 Fusing Belt Smoothing
Setting
Specify the condition to execute Fuser Belt smoothing.
0513 Smooth Fusing Belt Smooth the Fuser Belt to remove vertical and horizontal
lines from the printouts.
0516 Manage Multiple Fusing
Units by Counter
Display the counter of Fusing Unit parts.
Finishing: Finisher
For details about the following items, see page 184 "Finishing: Finisher".
No. Item Description
0601 Staple Position: Across
Feed 1
Adjust the vertical position of the staple (applied at an
edge) when using Finisher SR5050 or Booklet Finisher
SR5060.
0602 Staple Position: Across
Feed 2
Adjust the vertical position of the staples (dual) when
using Finisher SR5050 or Booklet Finisher SR5060.
0603 Staple Position: With Feed Adjust the horizontal position of the staples when using
Finisher SR5050 or Booklet Finisher SR5060.
0604 Paper Alignment for
Stapling: Across Feed
Adjust the width of the Staple Jogger
*1
when using the
staple function on Finisher SR5050 or Booklet Finisher
SR5060.
6. Adjustment Settings for Operators
162