0608 Punch Position: With Feed
Adjust the horizontal position of the punch holes when using Finisher SR5050 or Booklet Finisher
SR5060.
Press [ ] to move the position toward the top edge (left) relative to the paper feed direction, or [ ] to
move it toward the bottom edge (right).
Paper feed direction
Paper feed direction
2 Holes Top
2 Holes Left
CVK008
Setting Items
Default
Value
Max.
Value
Min.
Value
Step Unit
2 Holes JP/ EU
3 Holes US
4 Holes EU
4 Holes NE
2 Holes US
0.0 4.0 -4.0 0.5 mm
0609 Punch Skew Correction
Specify whether or not to correct the punch skew when using Finisher SR5050 or Booklet Finisher
SR5060.
If jamming or ear-fold occurs at the punch section especially when thin paper is used, set it to [No].
Setting Items Values Default Value
Set Off
On (Default)
On (Default)
0610 Amount of Punch Skew Correction
Adjust the level of skew correction when using Finisher SR5050 or Booklet Finisher 5060.
Setting Values
191
To Next Page
Loading...
