Ricoh Ri 100 - Control Panel and Power Management

20
2
Printing on Fabric
Loading a Fabric in the Sleeve Attachment
When printing on the sleeves of a fabric, attach the sleeve at-
tachment to the multi tray and load the sleeves in the sleeve
attachment.
If you perform printing with the edges of the fabric still outside of the
•
table, the fabric or this machine might be damaged. After fixing the
fabric, make sure that it fits within the width of the cassette.
When fixing sleeves with tape, stick the tape to the side of the sleeve
•
attachment. If you wrap the tape onto the bottom of the multi tray,
you may not be able to set the sleeve attachment correctly on the
cassette stand.
Tuck the protruding fabric under the front side and the side of the
•
sleeve attachment. If you only tuck the protruding fabric under the
front side, a height detection error may occur or the table may be
damaged because of the thickness of the fabric.
Press the [Power] key, and then turn on the machine.
• Detachthecassetteafterturningonthemachine.Ifyoude-
tach the cassette before turning on the machine, turn it off
first, and then turn it on again.
Make sure that the cas-
sette stand is out of the
machine, and then detach
the cassette.
• Ifitisnotoutofthemachine,
press the [Tray] key (Cas-
sette key) to eject the cas-
sette.
• Liftupthecassettelightlyandpullthecassettetodetachit.
DSB002