7
2
Printing on Fabric
Creation Flow
This section explains the operation flow when printing is per-
formed on fabric using the "Easy Designer" mode of the dedi-
cated "Design Software" application. This guide uses Windows
procedures for its examples.
Removing dust and flattening fibers of the fabric.
See page 11 "Removing Dust and Flattening Fibers".
Load the fabric in the cassette.
See page 12 "Loading a Fabric in the A4 Standard Tray",
page 17 "Loading a Fabric in the Multi Tray", and page 20
"Loading a Fabric in the Sleeve Attachment".
Select the type and thickness of the fabric.
Launch the Design Software and configure the settings for
the printing fabric you want to use.
To Next Page
Loading...
