Error Messages Troubleshooting
Cannot use High Temp. /
Power Off On
Cannot use Low Temp. /
Power Off On
The temperature is abnormally high or low. Check
the installation area and relocate the machine. Al-
ternatively, wait until the machine acclimates to the
room temperature.
Hardware Problem Ethernet
Board
An error in the Ethernet port (Ethernet board) net-
work function has occurred. Disconnect all cables,
turn the machine off, and then turn it on again.
If the message reappears, contact your sales or
service representative.
Ink Collector is not set / Set
the Ink Collector Unit
The ink collector unit is not installed or is installed
incorrectly. Alternatively, an ink collector unit not
meant for this machine may be installed. Install
the ink collector unit for this machine correctly. The
ink collector unit meant for this machine is labeled
"J089" under its handle.
Ink Collector Unit is full /
Replace Ink Collector Unit
The ink collector unit is full. Replace the ink collec-
tor unit.
Low Ink The ink will soon run out. Make sure you have a
new ink cartridge for the color indicated by
.
Maintenance in process... The machine is cleaning or flushing its print head.
Wait a moment. You might hear a clicking sound
while the maintenance is in process. This is not a
malfunction.
Maintenance failed Head cleaning, head flushing, or other mainte-
nance operations have failed. Run the mainte-
nance again after clearing the error. You can clear
a maintenance error when the machine receives
another print job or the [#Enter] key is pressed.
Open Front Cover / Replace
Ink Crtg
The ink has run out. Install a new ink cartridge for
the color indicated by
or .
See page 55 "Replacing an Ink Cartridge".
Open Front Cover / Reset
Cartridge
The ink cartridges are not installed or are installed
incorrectly. Alternatively, an ink cartridge not meant
for this machine may be installed. Install the ink
cartridge for this machine correctly.
To Next Page
Loading...
