Sub Scan
Magnification
Adjusts the sub scan magnification.
[-8 to 8 / 0 / 1 /step]
Development
Bias Setting
Adjusts the developer bias.
[270 to 330 / 300 / 15 /step]
Transfer Roller
Bias
Adjusts the transfer roller bias.
[-6 to 6 / 0 / 1 /step]
Curl Control
mode
Corrects the face curl of paper.
0: OFF (28ppm)
1: Sets the engine speed at 14ppm after printing 1 minute.
2: Sets the engine speed at 14ppm.
3 to 255: not available
[0 to 255 / 0 / 1 /step]
Settings
between near
empty and
empty of Toner
status
Printable Sheets
Adjusts the printable sheets between "toner
near end" to "toner end".
[0 to 255 / 200 / 1 sheet/step]
Printable Dot Count
Adjusts the printable dot count between "toner
near end" to "toner end".
[0 to 255 / 100 / 1 dot/step]
PDL Menu
ON = "PDL Settings" is shown (Default)
OFF = "PDL Settings" is hidden
Counter Information Display the counter information.
Clear Transfer Roller EM Counter Clears the EM counter of the transfer roller.
Clear Paper Feed Roller EM Counter Clears the EM counter of the paper feed roller.
Clear Fusing Unit EM Counter Clears the EM counter of the fusing unit.
Factory Default for Service
Resets all the settings to factory default.
Clears/ resets the contents of the
controller memory (all data
programmed by the user, log data
application counters) to factory default.
After executing, initial setup menu starts after
power-on.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
