2. Paper Specifications and Adding
Paper
This chapter describes how to load paper and originals and about their specifications.
Workflow for Loading Paper and Configuring
Paper Sizes and Types
This section explains how to load paper and operations required after paper is loaded.
After following the procedures below, you can print on the paper that is loaded in the machine.
Load paper into the paper tray.
Specify the paper type and size.
Specify the paper type and size on the printer driver.
DSG260
For details about the procedures, refer to the next page.
Procedure Reference
See page 20 "Loading Paper".
There are two ways to specify the paper type and size.
• When using Web Image Monitor
See page 31 "Specifying Paper Type and Paper Size Using Web
Image Monitor".
• When using Smart Organizing Monitor
See page 29 "Specifying Paper Type and Paper Size Using Smart
Organizing Monitor".
See page 32 "Specifying Paper Type and Paper Size Using the Printer
Driver".
For details about supported paper, see page 34 "Supported Paper".
19
To Next Page
Loading...
