Using Smart Organizing Monitor
95
7
Adjusting registration
On the [Maintenance] tab, you can adjust print starting positions.
Normally, you do not have to adjust registration. However, adjustment can
be useful in some cases, especially if you want to print in a specific position.
Under [Registration: Tray 1], [Registration: Tray 2], [Registration: Bypass Tray], and
[Registration: Duplex Tray] you can adjust the print image position printed on
the sheet fed from each tray. To check the adjustment result, use [Print Test
Sheet].
Setting basic functions
On the [System] tab, you can set the basic functions required to use the printer.
The printer can be used on factory-set defaults, but the configuration can be
changed depending on the condition of the user. The changed condition holds
even if the printer is turned off.
The access code can be changed on this tab.
Making network-related settings
On the [Network 1], [Network 2], and [Network 3] tabs, you can set configurations
about network connection and communication.
The following operations are possible on these tabs:
• Checking the device name and other printer information
• Making interface settings, including the timeout setting
• Checking or making TCP/IP settings
• Checking or making SMTP settings
• Checking or making SNMP and Alert settings
Settings conditions for printing
On the [Printer:] tab, you can set conditions for printing.
In the
[
PCL
]
area, you can specify the conditions such as Orientation and font settings.
Note
❒ Only PCL related settings can be modified in this area.
To Next Page
Loading...
