Preparing for Printing
8
1
Installing the Printer Driver in a Network
Environment
This section explains how to install the printer driver that allows you to use this
printer in a network environment.
Installing the PCL Printer Driver
The following four steps are required to use this printer in the network environ-
ment.
A Print the test page
B Install Smart Organizing Monitor if necessary
C Specify the printer's IP address if necessary
D Install the printer driver
Note
❒ If the printer is obtaining its IP address automatically from a DHCP server,
you do not need to perform "2. Install Smart Organizing Monitor" and "3.
Specify the printer's IP address".
Printing a test page
To install the printer driver, you must first confirm the printer's IP address.
If the printer is not obtaining its IP address automatically from a DHCP server,
enter the MAC address printed on the test page as the IP address in Smart Or-
ganizing Monitor.
Make sure the network cable is properly connected to the printer before you
print the test page.
A Turn the printer's power switch to off, and then wait a few seconds.
B While pressing down the {Job Reset} key, turn the printer's power switch
back to on, and then keep the key pressed down until the Alert indicator
flashes once.
C Printing starts when the printer is fully warmed up.
Printing starts approximately 30 seconds after the Alert Indicator starts flashing.
To Next Page
Loading...
