Exterior: Rear view
1. Ventilation holes
Prevent overheating.
2. Power connector
Connect the power cord to the printer. Insert the other end into an electrical outlet.
3. Paper tray cover
Prevent dust from getting into the paper tray when it is extended.
4. Rear cover
Open to access the inside of the printer.
Open here to replace the fusing unit or using the envelope lever.
5. Ethernet port
Use a network interface cable to connect the printer to a network.
6. USB port B
Use a USB cable to connect the printer to a computer.
7. USB port H (Port for use by customer engineer)
Do not use this port.
1. Getting Started
10
To Next Page
Loading...
