4. Squeeze the end guide and slide it inward to match the standard size.
5. Slide the two levers at the bottom of the tray according to the thickness of the paper.
If the paper is heavier than 130 g/m
2
(35 lb.), slide both levers into the rear (thick) position. If the
paper is 130 g/m
2
(35 lb.) or lighter, slide both levers into the forward (thin) position.
6. Load the new paper stack print side down.
Make sure paper is not stacked higher than the upper limit (upper line) marked inside the tray.
7. Adjust the paper guides to close any gaps.
Do not move paper loaded in the tray more than a few millimeters.
Moving the loaded paper excessively may cause damage to paper edges on the openings of the
tray's lifting plate, resulting in sheets being folded or becoming jammed.
Loading Paper into Paper Trays
39
To Next Page
Loading...
