Orientation Paper tray 1 Bypass tray
Envelopes
-
• Flaps: closed
• Bottom side of envelopes:
toward the right of the
printer
• Side to be printed: face up
Envelopes
*1
• Flaps
*2
: open
• Bottom side of envelopes:
toward the front of the
printer
• Side to be printed: face
down
• Flaps: open
• Bottom side of envelopes:
toward the back of the
printer
• Side to be printed: face up
When loading envelopes, use both the control panel and the printer driver to select "Envelope" for
the paper type and specify the thickness of the envelopes. For details, see page 53 "Configuring
Envelope Settings Using the Control Panel".
*1
To print on envelopes that are loaded with their long edges against the printer body, rotate the print
image by 180 degrees using the printer driver.
*2
If the flaps are not held with the end guide, the envelopes may not be fed properly. In this case, load
them into the bypass tray.
Recommended envelopes
For details about recommended envelopes, contact your local dealer.
The size of envelopes that you can load depends on the tray in which you load them. For details,
see page 28 "Paper Size Specifications".
• Load only one size and type of envelope at a time.
• The duplex function cannot be used with envelopes.
2. Loading Paper
48
To Next Page
Loading...
