Problem Solutions
Attached options are not
detected in the printer
properties.
• The computer and printer are not in bidirectional
communication. You must configure attached options in the
printer properties. For details, see the printer driver's Help.
• Once you perform an automatic update of device information
using the PCL 6 or PostScript 3 printer driver's properties,
other printer drivers may not be able to establish a
bidirectional communication and cannot perform the
automatic update successfully. This only occurs with 32-bit
Windows XP. In such cases, log off and log back on to
Windows, and perform the automatic update again. If the
problem cannot be resolved, contact your sales or service
representative.
When printing combined prints
or bound prints.
Check that the paper size and direction set in the printer driver are
the same as those set in the application.
If the settings are not the same, change the settings of the printer
driver.
An empty tray is selected by
Auto Tray Select, and the
document is not printed due to
out of paper error.
If a paper tray is opened and closed while the printer is in Energy
Saver mode, the printer will initialize the tray upon recovery, but
the tray will not be selectable by Auto Tray Select.
To print from a paper tray that you opened and closed while the
printer was in Energy Saver mode, you must manually specify the
tray as the source paper tray before printing. When the printer
recovers from Energy Saver mode and completes initialization, it
will then print the document from the tray you have specified.
Other Printing Problems
91
To Next Page
Loading...
Need help?
General
Weight and Dimensions
