Problem Solution
Multiple sheets of paper are fed at
once.
• Fan the paper well before loading. Also make sure that
the edges are aligned by tapping the stack on a flat
surface such as a desk.
• Make sure that the paper guides are in the right position.
• Use supported types of paper. See page 41 "Supported
Paper".
• Load paper only as high as the upper limit markings on
the paper guide.
• Make sure that the friction pads, paper feed rollers or
registration rollers are clean. See page 144 "Cleaning
the Friction Pad and Paper Feed Roller" and page 147
"Cleaning the Registration Roller and Paper Tray".
• Check that paper was not added while there was still
some left in the tray.
Only add paper when there is none left in the tray.
The printed paper is wrinkled. • The paper being used may be damp. Use paper that has
been stored properly. See page 41 "Supported Paper".
• Paper is too thin. See page 41 "Supported Paper".
• If there are gaps between the paper and the paper
guides, adjust the paper guides to remove the gaps.
• Check that both the left and right fusing unit levers have
been raised to the plain paper mark.
The printed paper is curled. • Load the paper upside down in the paper tray.
• If the paper curl is severe, retrieve prints from the output
tray more frequently.
• The paper being used may be damp. Use paper that has
been stored properly. See page 41 "Supported Paper".
• Select [Level 2] or [Level 3] in [Anti-Humid Lvl] under
[Maintenance]. Note that if you select [Level 2] or [Level
3], the first print takes longer than subsequent prints.
Paper Feed Problems
159
To Next Page
Loading...
Need help?
General
Weight and Dimensions
