Maintenance Menu
This section explains about parameters that can be set on the Maintenance menu.
Color Dens/Reg
Adjusts color density and registration automatically.
TonerAlmstEmpty
Specifies the low toner level notification timing.
Default: [Normal]
• Normal
Low toner level notification will be made when the number of pages that can be printed with
the remaining toner is approximately 200.
• Notify Later
Low toner level notification will be made when the number of pages that can be printed with
the remaining toner is approximately 100.
• Notify Sooner
Low toner level notification will be made when the number of pages that can be printed with
the remaining toner is approximately 300.
Anti-Humid Lvl
You can set the printer to produce prints in consistent quality even when humidity is high.
Default: [Off]
• Off
• Level 1
Select this mode if printouts are blurred.
• Level 2
Select this mode if printouts are curled and/or blurred. Note that if you select this mode, the
first print takes longer than subsequent prints.
• Level 3
Select this mode if printouts are still curled and/or blurred even when prints are made in
[Level 2]. Note that this mode requires more time to produce the first print than [Level 2].
4. Configuring the Machine Using the Control Panel
88
To Next Page
Loading...
