Message Cause Solution
"IPv6 Address already exists
Manual Config.
Address(109/209)"
The same IPv6 address is already
used.
Contact your network
administrator.
"Load paper in (tray name)
or [Cancel] to FormFeed."
There is no paper in the specified
tray.
Load the specified paper in the
tray, press [JobReset] to reset the
job. To print from the bypass tray
on paper whose width is less than
84 mm, cancel the print job, and
then, under [System], set [Bypass
Print: 64-84 mm] to [Active].
"May have exceeded max
no. of prints in output tray.
Print stopped. Check the
tray."
The output tray is full. Remove paper from the output
tray.
"Output Tray is full. Remove
paper."
The output tray is full. Remove the paper.
"Problem: Printer Font Error" There are problems with the
printer's font file.
Turn the printer off, and then turn it
on again.
If the problem persists, contact
your sales or service
representative.
"Problem:Wireless board
Please call service."
The printer cannot detect a
wireless LAN interface board.
Check that the wireless LAN
interface board installed correctly.
If the problem persists, contact
your sales or service
representative.
"Replace Fusing Unit." You will need to replace the
fusing unit soon.
Contact your sales or service
representative to obtain a new
unit.
"Replacemnt
Requird:IntTrans"
You need to replace the
intermediate transfer unit.
For details, see "Replacing Other
Consumables", Operating
Instructions.
"Replcmnt Requrd: Print
Cart"
The toner has run out, or the
photo conductor unit has reached
the end of its service life.
For details, see "Replacing the
Print Cartridge", Operating
Instructions.
When Messages Are Displayed
71
To Next Page
Loading...
Need help?
General
Weight and Dimensions
