For the most up to date documents, bike models, additional information, instructional videos,
And more visit us at Ride1UP.com
• It is best practice for safety, to only turn on your electric bike once you have lifted your leg over
the bike and are straddling the frame. You should turn it on before you begin riding, but only once
you are ready to ride.
• It is also best practice for safety to turn off the bike when you are done riding after you dismount
from the seat, but before you lift your leg over the bike to get off. If you stop to look at something
or talk with someone, please turn off your bike for safety.
• Once the bike is powered on, the throttle is active, if pushed it will cause the bike to accelerate. If
PAS is on and at 1 or higher, if the pedals are bumped and move forward when next to or moving the
bike, power will be sent to the motor and the bike will accelerate.
• Turning it on and off as described above will minimize the chance of the bike accelerating
unintentionally.
6.2 Pedal Assist Level
The assist level ranges from Level “0” to Level “5”. Level “1” is the minimum power and Level “5” is the
maximum. To change the assist level, press the UP or DOWN buttons until desired level is displayed.
6.3 Speed & Mileage mode switch
Pressing the POWER button can change the speed and mileage mode, AVG→SPEED→MAX SPEED→ TRIP
→ODO→TIME.
**If there is no operation for 5 seconds, display will return Speed (Real-Time) display automatically.
6.4 Backlight On/Off
Press and hold UP button for 2 seconds to turn on/off the display backlight.
6.5 Walk/push Assist (4mph)
Press and hold DOWN button for 2 seconds enters the walking mode until released.
6.6 Change settings
Hold the POWER button to enter the setting menus, press UP/DOWN buttons to change the parameter
setting, pressing the POWER button can switch to the next item. Holding the POWER button will exit from
menu.
NOTE:
◆
THE DISPLAY MAY VARY BASED ON GENERATION. PLEASE REFER TO OUR ONLINE USER
MANUAL BASE FOR UPDATED OR PREVIOUS MODELS.
7. Error Code Troubleshooting:
In the event of a problem with the electrical components of your bike, the display will show an error code.
The error code may only appear briefly when the problem occurs. If an error occurs and you can do so safely,
To Next Page
Loading...
