3
Before Using This Tool
WARNING: Some dust created
by power sanding, sawing, grind-
ing, drilling, and other construction
activities contains chemicals
known (to the State of California)
to cause cancer, birth defects or
other reproductive harm. Some
examples of these chemicals are:
• Lead from lead-bases paints,
• Crystalline silica from bricks and
cement and other masonry prod-
ucts, and
• Arsenic and chromium from
chemically-treated lumber.
Your risk from these exposures var-
ies, depending on how often you do
this type of work. To reduce your
exposure to these chemicals: work
in a well ventilated area, and work
with approved safety equipment,
such as those dust masks that are
specially designed to filter out
microscopic particles.
WARNING: To reduce the risk of
mistakes that could cause serious,
permanent injury, do not plug the
machine in until the following steps
have been satisfactorily completed.
NOTE: Do not cut masonry, stone
or ceramic. The fine dust created
when cutting these materials will
damage the motor. Failure to follow
this warning will void the warranty.
• Completely assemble and align tool.
(See “Assembly” and “Alignment”
sections within.)
• Learn the use and function of the
ON-OFF switch, upper and lower
wheel guards, arbor lock, and work-
piece clamp. (See “Getting to Know
Your Abrasive Cut-Off Machine”
section within.)
• Review and understand all safety
instructions and operating proce-
dures in this manual.
• Review the maintenance methods
for this tool. (See “Maintenance”
section within).
• Find and read the following labels
on the cut-off machine:
To prevent injury or
machine damage,
lock pin must remain
in the full left position
before operating ma-
chine. Do not push
lock pin while wheel is
turning.
PDFKLQH
ZLWKRXW
JXDUG
LQ
SODFH
FXWRII
ZKHHO
To Next Page
Loading...
