To Next PageTo Next Page
Need help?Do you have a question about the RIDGID R4010 and is the answer not in the manual?
General| Type | Table Saw |
|---|---|
| Motor Power | 15 Amps |
| Blade Diameter | 10 in |
| Weight | 90 lbs |
| Arbor Size | 5/8 inches |
| No Load Speed | 5000 RPM |
| Cord Length | 6 feet |
| Bevel Capacity | 0 to 45 degrees |
Guidelines for selecting and using extension cords safely and proper grounding instructions.
Lists detailed specifications of the tile saw, including dimensions and capacity.
Identifies and describes major parts like the laser alignment system, pump, and vehicle.
Guides for unpacking the saw and assembling its utility vehicle/leg stand.
Instructions for installing water tubes, pump, tray, and extensions.
Covers installing the miter guide, tile carrier, and cutting wheel.
Details aligning the laser guide and final setup steps.
Lists intended uses and explains the pump switch operation.
Explains the on/off switch, safety features, and saw arm adjustments.
Details how to perform cross cuts, rip cuts, and diagonal cuts.
Guides for performing bevel cuts and cutting pieces from the material center.
Steps for squaring the cutting wheel and adjusting table rollers.
Instructions for adjusting depth stop and positive stops for angles.
Steps for checking and replacing worn motor brushes.
Procedures for cleaning the saw components, water system, and submersible pump.
Details the 3-year limited service warranty and how to obtain service.
