To Next PageTo Next Page
Need help?Do you have a question about the RIDGID R4091 and is the answer not in the manual?
Details on chemicals known to cause cancer, birth defects, or reproductive harm.
Explains signal words (Danger, Warning, Caution, Notice) and common tool symbols.
Guidelines for selecting and using appropriate extension cords.
Details on connecting the tool to power and proper grounding procedures.
Overview of the saw's components and operational features.
Steps for safely unpacking the saw and checking for damage.
Instructions for securely attaching the handle to the water tank.
Detailed steps for assembling the utility vehicle and leg stand.
How to lock and unlock the saw's sliding tables for operation.
Steps for attaching the water tray frame and motor head assembly.
Instructions for installing the water tray and its extensions.
Guide for attaching the sliding table extension for added support.
How to install and adjust the miter guide for accurate cuts.
Steps for connecting the water pump and filling the water tank.
Instructions on how to fold and secure the leg stand for transport.
Steps for deploying the leg stand for operation or moving the saw.
Step-by-step guide for safely installing the tile cutting wheel.
Procedure for aligning the laser guide for precise cutting.
Details the intended uses and types of cuts the saw can perform.
How to operate the water pump switch and the main power switch.
How to lock and unlock the saw arm for specific cutting operations.
Instructions for adjusting the cutting head along the saw arm.
How to set the cutting depth using the depth stop mechanism.
Procedure for setting and adjusting the bevel angle of the cutting head.
Instructions for making straight 90-degree cross and rip cuts.
Guide for performing diagonal cuts on tiles.
Steps for making angled miter cuts on tiles.
How to perform L-cuts to fit tiles around corners or obstacles.
Instructions for making beveled cuts at various angles.
How to make plunge cuts to remove material from the center of a tile.
How to shorten garden pavers for landscaping projects.
Instructions for making corner cuts on garden pavers.
How to align the cutting wheel perpendicular to the table.
Procedure for ensuring smooth sliding of the table on its rails.
Adjusting the 0° and 45° positive stops for precise angles.
Adjusting the laser line to match the cutting wheel path.
Tips for cleaning plastic parts and lubricating moving surfaces.
How to check for and replace worn carbon brushes.
Instructions for rinsing and wiping down the main saw components.
How to clean debris from the submersible water pump.
Details on the 3-year limited warranty and 90-day satisfaction guarantee.
How to get warranty service and what is not covered by the warranty.
Information on how to contact customer service for parts and service.
General
