EasyManuals Logo

Riello ALU 150 PRO power User Manual

Riello ALU 150 PRO power
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
TECHNICAL ASSISTANCE CENTRE
50
In the case of temporary absences, weekends, short
trips, etc., proceed as follows:
- keep the
Mode
button pressed until the bar (1) moves
under the "stand-by" mode.
With the electrical power supply, indicated by the green
LED, and also the fuel supply remaining on, the boiler is
protected by the anti-freeze function:
Boiler anti-freeze: if the boiler temperature is less than
5°C the burner switches on at maximum output until the
boiler temperature reaches 10°C;
CH frost protection: this function is only active if an
outdoor temperature sensor is connected. If outside
temperature drops below -5°C the pumps are switched
on. If outside temperature is between -4° and 1.5°C, the
pumps are switched on for 10 minutes at intervals of 6
hours. If outside temperature is above 1.5°C the pumps
are switched off.
If the heating unit is not going to be used for an extended
period of time, proceed as follows to prepare it for shut-
down
- Set the main switch of the control panel to "off" and
check that the display switches off
- Set the system's main switch to "off"
- Close the fuel and water taps of the heating and domes-
tic hot water system
b Under these conditions the system is not pro-
tected against frost. Drain the heating and
domestic hot water systems to prevent freezing.
TEMPORARY SHUT-DOWN
PREPARING FOR EXTENDED PERIODS OF DISUSE
1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Riello ALU 150 PRO power and is the answer not in the manual?

Riello ALU 150 PRO power Specifications

General IconGeneral
BrandRiello
ModelALU 150 PRO power
CategoryBoiler
LanguageEnglish

Related product manuals