Riello Condexa Pro3 Series User Manual

22
USE AND ADJUSTMENT
8.4 Changing the user parameters
Pressing displays the following values in succession:
− manifold delivery temperature T1
− DHW temperature T3
− low temperature circuit delivery temperature T6.
To change the relative setpoints:
− press the “Set/esc” button: the relative value will appear, the two digits on the right will ash
− if the value should not be changed, press ”Set/esc” again to return to display mode
− if the value should be changed, press
and until the required value appears on the display. Press “OK” to save the new
value. The displayed value stops ashing and the display returns to the display mode
For example’s sake here below is a table showing the procedure for changing the setpoint value of the low temp. heating system
from 50 to 40°C.
POS. PROCEDURE DISPLAY
1 E.g. value read on display for high system 80° C
2
Press button
to enter display mode, press again and go to the rst of 6 digits to visualize the set
value (e.g. 50° C)
3 Press button ”Set/esc”
4
Press
to take the setpoint to the desired value (e.g. 40° C)
5 Press ”OK” to memorize the new value
6 After 3 secs. the display will return to the display mode with the new setpoint
If there is no change after pressing ”Set/esc” for 10 secs. (the desired value corresponding to the set one) the display returns to
display mode function.
If there is no operation after pressing buttons
and , after one minute the display will return to display mode. The new selected
value is not memorized.
8.5 Monitor mode
Press “Set/esc” for 5 seconds to access "Monitor" mode. This mode is used to check the operating values for every system unit (ad-
dresses from 1 to 60).
POS. OPERATIONS DISPLAY
1 From current T1 position at 80° C
2
Press ”Set/esc” for 5 secs. The displays shows it is possible to read the values or functional status of
unit 1
3
Press
or to scroll and read the values of the desired unit (e.g. g., unit 19)
4
Pressing
the rst value of the selected unit will appear. Afterwards by pressing the same button
the next values will be visualized.
(e.g. g., 1st value – ow temperature NTC 70° C).
5
Press ”Set/esc” to exit monitor mode. The display will return to display mode function if it is not
pressed within 5 minutes or if no operation has been done.

Riello Condexa Pro3 Series Specifications

General

Brand	Riello
Model	Condexa Pro3 Series
Category	Boiler
Language	English