Riello Condexa Pro3 Series User Manual

23
USE AND ADJUSTMENT
The following values for each single unit can be visualized with :
POS. DIMENSIONS DISPLAY
1 Flow temperature (e.g. 70° C)
2 Return temperature (e.g. 50° C)
3 Exhaust ue temperature (e.g. 60° C)
4
Ionization current (index from 0 to 99).
E.g. g. Ionization current index 44.
5
Fan PWM signal (%).
If PWM = 100%, it corresponds to 99 on the display. E.g. g. with 66%.
6 Flowmeter contact open and closed (e.g. g. contact open then contact closed)
7
Circulator or motor-driven valve individual unit on/off.
(e.g. g. circulator on then circulator off)
8
Maximum ionization current (range from 0 to 99) at rst attempt.
E.g. g. Maximum ionization current value on display 80.
9
Hours worked by unit (from 0 to 9999 hours)
E.g. g. 8050 hours: rst thousands and hundreds then tens and units will ap-
pear in succession and coupled on the display
8.6 Installer programming mode
The installer parameters can be changed by entering the password (22).
The installer level password makes it possible to view and change the user and installer parameters.
Procedure for accessing the programming mode:
POS. PROCEDURE DISPLAY
1
Manifold delivery temperature T1
(e.g. T1 = 80°C)
2 Press “Set/esc” and “OK” . After 5s, the second and third digits will ash
3
Use
and to enter the second number of the password (the right digit).
E.g: password = X2
4 Press “OK” to save the second number of the password
5
Use
and to enter the rst number of the password (the central digit).
E.g: password = 22
6
Press “OK” to conrm the password, if the password is incorrect, the card returns to the Display
mode. If it is correct, the rst parameter P06 is displayed
7
Press
and to scroll the parameters enabled by the password.
Press “Set/esc” to start to modify the parameters.
Now P-XX and the respective value will be shown alternatively on the display.
8
Press
and to change the parameter value.
Each time a button is pressed, the alternating display of the parameter and the respective value
stops for 5 seconds and only the value is displayed.
9 Press “OK” to save the new parameter value.
To exit the installer programming mode, press the “Set/esc” button.
See the chapter "Parameter list" for a complete list of the parameters.

Riello Condexa Pro3 Series Specifications

General

Brand	Riello
Model	Condexa Pro3 Series
Category	Boiler
Language	English