Riello RLS 160/E - Electrode and Ignition Pilot Adjustment; Burner Refitting

20095042
24
GB
Installation
4.10 Electrode and ignition pilot adjustment
Place the pilot and electrode as shown in Fig. 22.
The pilot works correctly at pressures ranging from 6 - 12” WC.
4.11 Burner refitting
➤ Refit the burner to the slide bars 3) (Fig. 25) at approximately
4” from the sleeve 4) - burner positioned as shown in (Fig. 12,
page 20) - insert the ignition electrode cables.
➤ Remove the extension bars 31) Fig. 6, page 12.
➤ Slide the burner up to the sleeve so that it is positioned as
shown in (Fig. 25);
➤ refit screws 2) (Fig. 25) on slide bars 3) including the safety
plate 15) Fig. 12, page 20;
➤ secure the burner to the sleeve by tightening screws 1);
➤ connect the oil pipes again by screwing on the two connectors
6) (Fig. 12, page 20).
WARNING
Make sure that the electrodes are positioned as
shown in Fig. 24.
1 3/8''
Fig. 22
D10530
Fig. 23
D10497
ELECTRODE
IGNITION PILOT
3/32"
5 / 3 2 " t o 3 / 1 6 "
Fig. 24
D10495
WARNING
When fitting the burner on the two slide bars, it is
advisable to gently draw out the high tension cables
until they are slightly stretched.
Fig. 25
2
3
1
4
5
14
6
20097600